sales@mrv.com op datasheet pluggables sfp multi rate bidirectional transceivers SFP-MR-35IR1 and sfp-mr-53ir1 general operating parameter symbol min. typical max. unit supply voltage v cc 3.135 3.3 3.465 v total current i cc - - 300 ma power supply noise rejection psr 100 - - mv p-p operating temperature t op -5 - 70 oc storage temperature t st -40 - 85 oc data rate dr 100 - 2700 mbps transmitter speci cations (optical) parameter symbol min typical max unit optical power p op -5 -2.5 0 dbm optical crosstalk xt - - -45 db average launch power (tx: off ) p off - - -45 dbm extinction ratio er 8.2 - - db eye mask ieee 802.3 and sonet/sdh compliant optical rise time (20% - 80% values) t r - - 160 ps optical fall time (20% - 80% values) t f - - 160 ps mean wavelength: SFP-MR-35IR1 1280 1310 1335 nm sfp-mr-53ir1 1480 1550 1580 nm spectral width (20 db) --1nm side mode suppression ration smsr 30 - - db dispersion penalty (at 15 km)1 dp - 0.5 1 db relative intensity noise rin - - -120 db/hz transmitter re? ectance - - - -12 db re? ectance tolerance rp -24 - - db 1) measured at 2.7 gbps, ber of 10 -12 , prbs of 2 23 -1, at eye center 100 mbps-2.7 gbps data rates oc-48/stm-16 standard compliances ieee 802.3ah, 1000base-bx10 compatibility simplex lc connector 13 db minimum power budget 15 km minimum reach single 3.3 v supply 1310 nm or 1550 nm dfb laser digital diagnostic sff-8472 compliance telcordia gr-468 compliance gr 253/stm g.957 compliance rohs and china rohs compliance sfp msa sff-8074i compliance 21cfp 1040.10 and 1040.11 compliance tv compliance commercial temperature rating class 1 laser color coded bail latch: blue or yellow features
pluggables sales@mrv.com transmitter speci cations (electical) parameter symbol min typical max unit input differential impedence r in 80 100 120 pecl single ended data input swing v in,p-p 250 - 1200 mv txfault_fault v fault 2-v cc v txfault_normal v normal v ee -v ee +0.5 v txdisable_disable v d 2-v cc v txdisable_enable v en v ee -v ee +0.8 v receiver speci cations (optical) parameter symbol min typical max unit receive power low 2 r sens,low - -20 -18 dbm receive power high 2 r sens,high 0 - - dbm damage threshold for receiver p in,damage - - 0 dbm wavelength: SFP-MR-35IR1 1480 - 1600 nm sfp-mr-53ir1 1260 - 1360 nm los assert - -28 - - dbm los de-assert - - - -18 dbm los hysteresis - 0.5 - - db receiver re? ectance - - - -12 db 2) measured at 10 -10 ber, 2.7 gbps, 2 23 -1 prbs, and 10 -12 ber, 1250 mbps, 2 7 -1 prbs receiver speci cations (electrical) parameter symbol min typical max unit pecl single ended data output swing v out, p-p 185 - 800 mv data output rise time t r - - 175 ps data output fall time t f - - 175 ps timing and electrical parameter symbol min typical max unit tx disable negate time t_on - - 1 ms tx disable assert time t_off - - 10 s time to initialize, including reset of tx fault t_init - - 300 ms tx fault assert time t_fault - - 100 s tx disable to reset t_reset 10 - - s los assert time t_loss_on - - 100 s los de-assert time t_loss_off - - 100 s serial id clock rate f_serial_clock - - 100 khz rx_los voltage (high) rx_los h 2- -v rx_los voltage (low) rx_los l - - 0.8 v los output voltage-fault v los fault 2 - v cc v los output voltage-normal v los normal v ee -v ee +0.5 v mod_def (0:2)-high v h 2-v cc v mod_def (0:2)-low v l v ee -v ee +0.5 v
pluggables sales@mrv.com digital diagnostics parameter range accuracy unit calibration bit value formula temperature -5 to 70 3 o c internal 1/256 c tc(c)=tad(16 bit signed twos complement)/256 voltage 0 to v cc 0.1 v internal 100 v v(volts)=vad(16 bit unsigned integer)*0.1 bias current 0 to 120 5 ma external 0.002 ma i(ma)=islope*iad(16 bit unsigned integer)+ioffset tx power -5 to 0 2 db dbm external 0.1w tx_pwr(w)=tx_pwrslope*tx_pwrad(16 bit unsigned integer +tx_pwroffset rx power -18 to 0 2 db dbm external 0.1w rx_pwr(w)=a0+a1*x+a2*x^2+a3*x^3+a4*x^4 pin function notes 1v ee t tx ground 2 tx_fault open collector 3 tx_disable internally pulled high 4 mod_def2 serial data input 5 mod_def1 serial clock input 6 mod_def0 internally grounded 7 nc not connected 8 los open collector 9v ee r rx ground 10 v ee r rx ground 11 v ee r rx ground 12 rxd- rx data negative 13 rxd+ rx data positive 14 v ee r rx ground 15 v cc r rx power 16 v cc t tx power 17 v ee t tx ground 18 txd+ tx data positive 19 txd- tx data negative 20 v ee t tx ground
mrv-op-sfpmr3553ir1-092507 copyright ?2007 mrv communications, inc. all rights reserved. 3020020-001 rev. a1 mrv (west coast usa) 20415 nordhoff st. chatsworth, ca 91311 800-338-5316 818-773-0900 mrv (east coast usa) 295 foster st. littleton, ma 01460 800-338-5316 978-952-4700 mrv (international) business park moerfelden waldeckerstrasse 13 64546 moerfelden-walldorf germany tel. (49) 6105/2070 fax. (49) 6105/207-100 mrv has more than 50 offices throughout the world. addresses, phone numbers, and fax numbers are listed at www.mrv.com. please e-mail us at sales@mrv.com or call us for assistance. all statements, technical information and recommendations related to the products herein are based upon information believed to be reliable or accurate. however, the accuracy or completeness thereof is not guaranteed, and no responsibility is assumed for any inaccuracies. please contact mrv communications for more in formation. mrv communications and the mrv communications logo are trademarks of mrv communications, inc. other trademarks are the property of their respective holders. pluggables outline drawing units in mm (inches) ordering information model description data rate wavelength (nm) bail latch color distance range (km) SFP-MR-35IR1 sfp multi rate bidirectional transceiver 100 - 2700 mbps 1310/1550 blue 0 -15 sfp-mr-53ir1 sfp multi rate bidirectional transceiver 100 - 2700 mbps 1550/1310 yellow 0 -15
|
